Ex2028 PoE
Ex2028 PoE

Ex2028 PoE

66060001

Los switches cnMatrix ™ EX2028-P simplifican la implementación y el funcionamiento de la red. Cuando se implementan con puntos de acceso WLAN cnPilot ™ y el sistema de gestión cnMaestro ™, los operadores de red tienen una red unificada de alta calidad con cable, inalámbrica, unificada y de alta calidad. Mejore el rendimiento, la seguridad y la satisfacción del usuario final al tiempo que reduce los costos con cnMatrix EX2028-P.

The cnMatrix series of fully managed switches delivers full Layer 2 and Layer 3 capabilities with enhanced access security. Depending on the model, the cnMatrix EX2000 series offers flexibility with SFP+ (10 Gbps) or SFP (1 Gbps) uplink ports. These switches come with a 5-Year Limited Lifetime Warranty
PRODUCT  
Model/Part# See table below for full set of Model and Part Numbers
SPECTRUM  
Channel Spacing Configurable on 5 MHz increments
Frequency Range 5150 - 5970 MHz (exact frequencies as allowed by local regulations) 
Channel Width 5 I 10 I 20 I 40 MHz
INTERFACE  
MAC (Media Access Control) Layer Cambium proprietary and optionally standard 802.lln
Physical Layer 2x2 MIMO/OFDM
Ethernet Interfaced 100/lOOOBaseT, rate auto negotiated, 802.3at compliant
Powering Methods Supported 56 V PoE (included), standard 802.3at PoE Supply, or CMM4 with 56 V and 5 pin to 7 pin cross over cable adapter
Protocols Used IPv4/IPv6 (Dual Stack), UDP, TCP, ICMP, SNMPv2c, NTP, STP, IGMP, SSH
Network Management IPv4/IPv6, HTTPs, SNMPv2c, SSH, Cambium Networks CnMaestro™
VLAN 802.lQ with 802.lp priority
PERFORMANCE  
Subscribers per Sector Up to 120; Lite version limited to 10
ARQ Yes
Nominal Receive Sensitivity (w/FEC) @20MHz Channel MCSO = -93 dBm to MCS15 = -69 dBm (per branch)
Nominal Receive Sensitivity (w/FEC) @40MHz Channel MCSO = -90 dBm to MCS15 = -66 dBm (per branch)
Modulation Levels (Adaptive) MCSO (BPSK) to MCS15 (640AM 5/6)
GPS Synchronization Yes, via internal GPS or CMM4 with 56 V and 5 pin to 7 pin cross over cable adapter
Quality of Service Three-level priority (Voice, High, Low) with packet classification by DSCP, COS, VLAN ID, IP & MAC Address, Broadcast, Multicast, 
and Station Priority
Transmit Power Range 0 to +30 dBm (combined, to regional EIRP limit) (1 dB interval)
RECOMMENDED ANTENNAS  
Sector Antenna ePMP Sector Antenna (C050900D021A) available
ePMP 2000 Smart Antenna ePMP 2000 Smart Antenna (C050900D020A) available (complimentary; does not replace Sector Antenna)
PHYSICAL  
Sector Antenna Connection 2 x 50 ohm, RP (reverse polarity) SMA
Beamforming Antenna Connection 2 x 50 ohm, RP (reverse polarity) SMA, DC coupled (powering antenna)
GPS Antenna Connection 1 x 50 ohm, RP (reverse polarity) SMA
Surge Suppression 1 Joule Integrated
Environmental IP55
Temperature -30°C to +55°C (-22°F to +131°F)
Power Consumption 20 W Maximum [1]
Input Voltage 44 V to 59 V
Weight 0.7 kg (1.54 lbs.) without brackets
Dimensions 125 x 210 x 37 mm (4.9 x 8.3 x 1.5 in.) without brackets
Pole Mount Included Yes
Environmental Cover Included Yes
SECURITY  
Encryption 128 bit AES (CCMP mode)
CERTIFICATIONS  
FCCID Z8H80FT0020
Industry Canada Cert 109W-0020
CE

EN 301 893 V2.1.1  

EN 302 502 V2.1.1

Notes:
[1] The maximum power consumption of the Access Point is the same regardless of whether the optional Smart
Beamforming Antenna is equipped or not. This is because the Beamforming Antenna draws its power during the uplink
cycle when the Access Point power consumption is not at its maxium.

Artículos relacionados